If you intend to create VLAN subinterfaces rather than a single physical interface on a given port, you would For non-bridge group members, you also need to give the interfaceĪn IP address. The interface is a member of a bridge group, this is sufficient. At minimum, you need to name the interface and enable it for it to pass traffic. When you attach a cable to an interface connection (physically or virtually), you need to configure the interface. The following topics explain how to configure the interfaces onįTD includes data interfaces as well as a Management /Diagnostic interface. Configure Hardware Bypass for Power Failure (ISA 3000).Configure a Physical Interface in Passive Mode.Configure the VLAN for a FTDv Passive Interface.Configure the Switch for a Hardware FTD Passive Interface.Configure VLAN Subinterfaces and 802.1Q Trunking.Maximum Number of VLAN Subinterfaces by Device Model.Limitations for Interface Configuration.Guidelines and Limitations for Interfaces. ![]() Limitations for Management/Diagnostic Interface Configuration for a Separate Management Network.Recommendations for Configuring a Separate Management Network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |